|
Technical Specs: EpoxyGator®
Wood Stick
Two component, ready to use simply by cutting amount desired,
kneading by hand to a uniform consistency and apply. Bonds
tenaciously to wood. Wood Stick epoxy putty has the same
characterizes of wood and cab be used on the interior and exterior.
COLORS AVAILABLE: NATURAL WOOD
● Excellent for wood repairs.
● Non-Shrink Properties
● Can be drilled, tapped, sanded, sawed, machined, sculpted and even
painted
● Fill crack voids, holes, gouges.
● Repair fine furniture. Moldings, frames, knobs, wood carvings,
exotic wooden pieces.
● Repair stripped screw and nail holes, dry rot etc.
● Contains no solvents, thus non-flammable
Directions for use:
Area must be clean and free of oils and dirt. For best results use
a wire brush to scratch the surface to ensure proper bonding. If
any oil is present, please wash/wipe it away using a solvent or
cleaner.
Cut the desired amount using a knife. Mix by kneading to a uniform
consistency. All our epoxy putty sticks are two component and are
conveniently colored. While mixing make sure both colors have
blended well. Cooler weather will make the epoxy hard to mix.
Simply heat up the epoxy stick until room temperature and use.
After mixing, immediately apply within 2 minutes to the area. During
the curing phase, material can be smoothed using slight damp
fingers. Wash hands with soap and water after use.
Pot Life: Approximately 15 minutes depending upon ambient
temperature
Initial Cure: 15 minutes to harden
Full Cure: 60 minutes
Shelf Life: 1.5 Years Unopened Containers
Compressive Strength: 12,350 lbs p.s.i
Shrinkage: <1
VOC Content: 0%
Operating Temperature: 300 F
Chemical Resistance: Resistant to all general MRO liquids.
Please contact 516-624-9774 for
Chemical Resistance Chart
Packaging: 4oz. (Length 7 1/8 Inches)
Cured Color: Wood Natural
|
Repair
corners, cracks and holes in wood