Technical Specs: EpoxyGator® Steel
Stick - SIZE: 7", 4oz.
Two component, industrial strength, steel reinforced, ready to use simply by cutting amount desired,
kneading by hand to a uniform consistency and apply. Bonds to all metals
including aluminum. Steel stick epoxy putty will also bond to wood, concrete and
glass.
● Excellent for Emergency Repairs to Metals. Seal, Bond, Repair & Refurbish
● Non-Rusting ● Non-Shrink Properties
● Can be drilled, tapped, sanded, machined and even painted
● Seal Leaks in Pipes & Tanks
● Fill crack and voids ● Repair casts
● Repair stripped threads in nuts and
bolts
● Contains no solvents, thus non-flammable
Directions for use:
Area must be clean and free of oils and dirt. For best results use a wire brush
to scratch the surface to ensure proper bonding. If any oil is present, please
wash/wipe it away using a solvent or cleaner.
Cut the desired amount using a knife. Mix by kneading to a uniform consistency.
All our epoxy putty sticks are two component and are conveniently colored. While
mixing make sure both colors have blended well. Cooler weather will make the
epoxy hard to mix. Simply heat up the epoxy stick until room temperature and
use. After mixing, immediately apply within 1.5 minutes to the area. During the
curing phase, material can be smoothed using slight damp fingers. Wash hands
with soap and water after use.
Pot Life: Approximately 3 minutes depending upon ambient temperature Initial
Cure: 8 minutes to harden Full Cure: 60 minutes Shelf Life: 1.5 Years Unopened
Containers Compressive Strength: 12,350 lbs p.s.i Shrinkage: <1 VOC Content: 0%
Operating Temperature: 300 F Chemical Resistance: Resistant to all general MRO
liquids. Please contact 516-624-9774 for Chemical Resistance Chart Packaging:
Sizes available: Cured Color: Dark Gray
Two
copper plates bonded together with an aluminum plate with Steel Stick Putty.
Drilled and tapped to allow a nut to thread
