|
Technical Specs: EpoxyGator®
Copper Stick Epoxy
Two component, ready to use simply by cutting amount desired, kneading
by hand to a uniform consistency and apply. Excellent for all copper
parts and equipment but also bonds to brass & bronze. This epoxy putty
will also bond to wood, concrete and glass.
● Excellent for Emergency Repairs to Metals. Seal, Bond, Repair &
Refurbish
● Non-Shrink Properties
● Can be drilled, tapped, sanded, machined and even painted
● Seal keaks in Pipes & Tanks. Stop plumbing leaks within minutes. Even
slow leaks!
● Seal copper gutters, spouts, traps, joints, sleeves etc.
● Fill crack and voids
● Bonds to wet and damp surfaces
● Repair casts
● Repair stripped threads in nuts and bolts
● Contains no solvents, thus non-flammable
Directions for use:
Area must be clean and free of oils and dirt. For best results use a
wire brush to scratch the surface to ensure proper bonding. If any oil
is present, please wash/wipe it away using a solvent or cleaner. Damp
surface is okay.
Cut the desired amount using a knife. Mix by kneading to a uniform
consistency. All our epoxy putty sticks are two component and are
conveniently colored. While mixing make sure both colors have blended
well. Cooler weather will make the epoxy hard to mix. Simply heat up
the epoxy stick until room temperature and use. After mixing,
immediately apply within 1.5 minutes to the area. During the curing
phase, material can be smoothed using slight damp fingers. Wash hands
with soap and water after use.
Pot Life: Approximately 3 minutes depending upon ambient temperature
Initial Cure: 5 minutes to harden
Full Cure: 60 minutes
Shelf Life: 1.5 Years Unopened Tubes
Compressive Strength: 12,350 lbs p.s.i
Shrinkage: <1
VOC Content: 0%
Operating Temperature: 300 F
Chemical Resistance: Resistant to all general MRO liquids.
Please contact 516-624-9774 for Chemical
Resistance Chart
Packaging: 4oz. (Length 7 1/8 Inches)
Cured Color: Copper
|
