Technical Specs: EpoxyGator®
Aqua Stick (WET & UNDERWATER APPLICATIONS)
Two component, fiberglass reinforced, ready to use simply by cutting
amount desired, kneading by hand to a uniform consistency and apply.
Bonds to metals including aluminum. Aqua stick epoxy putty will also
bond to wood, concrete, glass and most plastics.
● All purpose wet or underwater epoxy repair system
● Excellent for Fiberglass
● Non-Shrink Properties
● Can be drilled, tapped, sanded, machined and even painted
● Seal Leaks in Pipes & Tanks
● Fill crack and voids
● Excellent for marine applications
● Repair leaking gaskets, spas, pool cracks, hot tubs, jacuzzi's
● A must in every boaters tool kit
● Contains no solvents, thus non-flammable
Directions for use:
Area must be clean and free of oils and dirt. For best results use a
wire brush to scratch the surface to ensure proper bonding. If any oil
is present, please wash/wipe it away using a solvent or cleaner. Wet
surfaces are okay as this product is moisture insensitive.
Cut the desired amount using a knife. Mix by kneading to a uniform
consistency. All our epoxy putty sticks are two component and are
conveniently colored. While mixing make sure both colors have blended
well. Cooler weather will make the epoxy hard to mix. Simply heat up
the epoxy stick until room temperature and use. After mixing,
immediately apply within 10 minutes to the area. During the curing
phase, material can be smoothed using slight damp fingers. Wash hands
with soap and water after use.
Pot Life: Approximately 12 minutes depending upon ambient temperature
Initial Cure: 25 minutes to harden
Full Cure: 60 minutes
Shelf Life: 1.5 Years Unopened Containers
Compressive Strength: 12,350 lbs p.s.i
VOC Content: 0%
Operating Temperature: 300 F
Chemical Resistance: Resistant to all general MRO liquids.
Please contact 516-624-9774 for Chemical
Cured Color: White