|
Technical Specs: EpoxyGator®
Alumina Stick
Two component, aluminum reinforced, ready to use simply by cutting
amount desired, kneading by hand to a uniform consistency and apply.
Bonds tenaciously to aluminum. Alumina stick epoxy putty will also bond
to other ferrious metal, wood, concrete, glass and most plastics.
● Excellent for all Aluminum parts and equipment.
● Non-Shrink Properties
● Non-Rusting
● Can be drilled, tapped, sanded, machined and even painted
● Seal Leaks in Pipes & Tanks
● Fill crack and voids
● Repair aluminum boats, canoes, castings, pipes, tanks, aluminum
siding, gutters, windows
● Contains no solvents, thus non-flammable
Directions for use:
Area must be clean and free of oils and dirt. For best results use a
wire brush to scratch the surface to ensure proper bonding. If any oil
is present, please wash/wipe it away using a solvent or cleaner.
Cut the desired amount using a knife. Mix by kneading to a uniform
consistency. All our epoxy putty sticks are two component and are
conveniently colored. While mixing make sure both colors have blended
well. Cooler weather will make the epoxy hard to mix. Simply heat up
the epoxy stick until room temperature and use. After mixing,
immediately apply within 5 minutes to the area. During the curing phase,
material can be smoothed using slight damp fingers. Wash hands with soap
and water after use.
Pot Life: Approximately 5 minutes depending upon ambient temperature
Initial Cure: 10 minutes to harden
Full Cure: 60 minutes
Shelf Life: 1.5 Years Unopened Containers
Compressive Strength: 12,350 lbs p.s.i
Shrinkage: <1
VOC Content: 0%
Operating Temperature: 300 F
Chemical Resistance: Resistant to all general MRO liquids.
Please contact 516-624-9774 for Chemical
Cured Color: Aluminum Gray
|
